Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

FXO Ports

Hi,

I have a 2811 router that I need to install a 4 port FXO card. (VIC2-4FXO) The card is support in the HWIC slot according to Cisco, I do see it when I do a Show Version however I do not see the ports in the runnning config.

Thanks

7 REPLIES
VIP Purple

Re: FXO Ports

The VIC2-4FXO requires a minimum IOS of 12.3(8)T4 and a minimum feature set of IP Voice. See the link below for confirmation. Does your 2811 meet these requirements?

http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd801c595e.html

Hope this helps. If so, please rate the post.

Brandon

Community Member

Re: FXO Ports

I have the following IOS:

(C2800NM-ADVENTERPRISEK9-M), Version 12.4(9)T

Thanks

Bronze

Re: FXO Ports

am,

youre seeing in the running config, voice-card X right? might be voice-card 1 or something like that,

configure you codec to suite and issue a no shut. the voice ports should then be up

Community Member

Re: FXO Ports

i have problem like that so i'm trying change my IOS but if i see in running config just show voice-card 0 and i not see voice-port X. If i restart my router, in bootrap i see 4 Voice Port FXO but i can't see voice-port in running config so i can't configure voice-port to up

Bronze

Re: FXO Ports

just a thought....

do you guys have PVDM2 installed???

Ken

Community Member

Re: FXO Ports

how i know PVDM2 is installed on my router ?????

Bronze

Re: FXO Ports

show diag....

If you do not see any PVDM2-8,16,32,64 there... then you need to install.

Ken

144
Views
0
Helpful
7
Replies
CreatePlease to create content