I am working on a problem where an VIC2-4FXO voice port which connects to a Bogen UTC1 paging system intermittently hangs. A shut/no shut of the port clears the problem. Problem occurs approximately once a week. Polarity is correct on the connection between the FXO and Bogen. Trunk is setup as loopstart. Router voice port config only has default "timing hookflash-out 50".
I found a Bogen doc on the net but it didn't elude to what type of supervisory disconnect it used. I do not know whether the voice port shows off-hook or not when it hangs as I just got called into the problem. Does anyone have any suggestions or ideas? Thanks, Mike.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.