Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

FXO to Carrier question

Hi,

I have a CME with a FXO to our carrier, out going calls are not a problem but would like all calls entering the FXO port to go to a certain extension. At the moment incoming calles a picked up buy the router but get busy tone.

What would be the best way to get incoming calls to function..

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: FXO to Carrier question

Configure PLAR and route calls to the internal DNs.

Use the command connection plar-opx XXXX <<< extension number. This is configured under the FXO voice-port.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_administration_guide_book09186a0080380ccc.html

Gonzalo

1 REPLY
Green

Re: FXO to Carrier question

Configure PLAR and route calls to the internal DNs.

Use the command connection plar-opx XXXX <<< extension number. This is configured under the FXO voice-port.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_administration_guide_book09186a0080380ccc.html

Gonzalo

96
Views
0
Helpful
1
Replies
CreatePlease login to create content