We have a 2621 with an FXS card at a remote site. This eventually connects to a 3660 with a T1 controller running E&M immediate-start. The T1 controller is connected to a Nortel 81C. From the 81C, we can make successful calls to the telephone connected to the FXS port. At the far end, when we dial the destination pattern of the 3660 (48), we hear dialtone from the PBX. We can not break this dialtone however in order to dial a local. Help!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...