Here is a question for you guys. I want to strip out of my AVVID cluster/PRI a couple Lines to drop into a FAX Server. Normally I do this with a dedicated PRI going into a Fax board, but what I would like to do is use a Fax Server with a Analog 2 port DID card in it. My Question is *which* card (VWIC) do I interface to? A VWIC-2DID, 2FXS, 2FXO or a e&m? I haven't found any good documentation on this. I know if I was using just a normal Analog fax board it would be an FXS but since I'm using a DID board and I want to route about 50 DN's from the CCM out to this VWIC/Gateway and into the fax server I will need a DID capable board.
Please advise.
-jjf-