Here is a question for you guys. I want to strip out of my AVVID cluster/PRI a couple Lines to drop into a FAX Server. Normally I do this with a dedicated PRI going into a Fax board, but what I would like to do is use a Fax Server with a Analog 2 port DID card in it. My Question is *which* card (VWIC) do I interface to? A VWIC-2DID, 2FXS, 2FXO or a e&m? I haven't found any good documentation on this. I know if I was using just a normal Analog fax board it would be an FXS but since I'm using a DID board and I want to route about 50 DN's from the CCM out to this VWIC/Gateway and into the fax server I will need a DID capable board.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...