FXS/FXO tfunk problem - FXS port still UP after call end (on-hook) - C2851
I have configured this situation:
Analog phone <-->FXS-PBX-FXO <-->FXS-2851(CCME) <--> IP Phones. Calls goes OK. BUT I have problem with FXS. After on hook of IP phone, FXS port is staying in UP untill on hook-on analog phone. Second direction, I mean when analog phone is on-hooked first, FXS goes down correctly.
Re: FXS/FXO tfunk problem - FXS port still UP after call end (on
Many times when there is an FXO interface involved you can have disconnect supervision issues on the FXO port. From your description it looks like the FXO port in this case is on a PBX. Is there any PBX parameters you could try to fine tune on the FXO port regarding disconnect supervision? Is there a way on the PBX to monitor if the FXO port shuts down at the same time the IP phone hangs up?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.