I have a WAN link between our two sites is coming up that will terminate on VWIC-2MFT-G703 card on both sides. I have 2811 on both sides. When I installed the G703 card, it showed up as E1 controller. For its initialization, I issued the following commands under E1 controller configuration:
channel-group 0 unframed
clock source internal
Doing so created a serial interface on the router. I gave the IP to this interface. Do I need to do anything else before terminating the circuit?? Thank You in advance.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...