I have two sites. Within the sites are G.711 and between the sites are G.729. I have configured DSP on the central voice router to have hardware conferece bridge successfully register with CCM. But however when I tried to do either ad hoc or meet me, conference across the WAN still didn't work.
I had this last week. The way I got around things was to put the conference bridge in the remote device pool, and add an IOS transcoder (dspfarm transcoder maximum sessions 12) to the central router. The transcoder should be in the central Device Pool. This way, if a meet me is initiated from a remote phone, the hardware CFB is used, and if a meet me is enabled from a central phone, CCM will use transcoder resources to talk to the remotes. Works with a combination of both XCODE and Hardware CFB quite well. Just remember the device pool memberships.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...