I'm finding with testing that only when codec G723ar53/63 is used does VAD work. When G723r53/63 is used, VAD does not work. Why is this??? VAD is on by default on Cisco gateways, so shouldn't it work with any codec??
If you could point me to the specs for that codec that would be helpful. In addition, during subsequent testing, it appears VAD DOES work sometimes w/ G723r53/63 (non-annex A). Another Cisco engineer has indicated that VAD will work w/ other than Annex A codec with "special configuration changes on VoIP gateway". I've asked them to clarify that for me. Do you (or anyone else on the forum) know of anything like this? All documentation links are greatly appreciated around this considering that CCO docs are limited and contridictary on this subject.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.