I had developed a full-feature calling card system, the only problem now is it can only talk G711.
I digged into Cisco's TAPI development guide and found that I need to send device specific calls to have G723. So, I did; constructed a very nice little DLL so I can use it under VB too!
But, more problem comes. Under G723, I can never seems to get wave/in and wave/out devices thru lineGetID. TAPI replied device not available. Remove device specific calls, everything works again but only G711. The wave/in and wave/out is crucial for playing prompts, etc; so it must be there.
Is there something I missed here? Any programmer out there that had experience with this?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...