Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

Gatekeeper to Gatekeeper Authentication

Chicago GKPR:-

gatekeeper

zone local chicago chicago.test.net 192.168.62.254

zone remote dallas test2.net 192.168.40.254 1719

zone prefix dallas 3*

zone prefix chicago 5*

security password-group dal lrq receive test encrypted

security password-group dal lrq send test encrypted

security zone dallas password-group dal

gw-type-prefix 5* default-technology

timer lrq seq delay 1

timer lrq window 10

no shutdown

Dallas GKPR:-

gatekeeper

zone local dallas test2.net 192.168.40.254

zone remote chicago chicago.test.net 192.168.62.254 1719

zone prefix dallas 3*

zone prefix chicago 5*

security password-group chic lrq receive test encrypted

security password-group chic lrq send test encrypted

security zone chicago password-group chic

gw-type-prefix 4#* default-technology

timer lrq seq delay 1

no shutdown

For some reason, I cannot make calls between the two zones. Receive a InvalidPermission rejectReason in debugs. If I remove the security zone command, I can make calls between the chicago and dallas zones.

The Cisco doc gives example and states a border gatekeeper in between the originating and terminating gatekeeper, which acts like a relay to authenticate and forward lrq between the orginating and terminating gatekeepers. Not sue if the border gatekeeper is always needed.

Any help is appreciated !!

2 REPLIES
Silver

Re: Gatekeeper to Gatekeeper Authentication

The following document has good scenario on Gatekeeper to Gatekeeper Authentication.

Have a look at it.

Gateway to Gatekeeper (H.235) and Gatekeeper to Gatekeeper (IZCT) Security Troubleshooting Guide

http://www.cisco.com/warp/public/788/voip/gw_security.html

Silver

Re: Gatekeeper to Gatekeeper Authentication

The document is for IZCT. I am not using IZCT, I am trying with "security password" commands.

Thanks,

Partha

136
Views
0
Helpful
2
Replies
CreatePlease login to create content