I'm just wondering if somebody seen this behavior before. When callmanager (3.3) looses connection to the gatekeeper (i.e. WAN link down) , after the link is comming back i still cannot place any calls thru gatekeeper unless the ccm serevice is restarted.
I tested this and is working fine for me. Only thing is that after the WAN link comes back up, I have to wait for the duration specified by "registration retry timeout" (in gatekeeper config in CCMAdmin) for CCM to register back to the gatekeeper. By default, it is 300 secs.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...