I've a problem with a 2621 ( 2 Ethernet-NICs) including 1 voice-pri module. There are almost all IP-Phones in the IP-network from NIC 1. In CCM 3.08 i've an gateway-entry for the 2621 and in my dns i've an A-record for the first NIC. All calls from my first IP-Network to the PSTN works OK. But there are a few IP-Phones in the IP-Network from the second NIC. All internal calls works OK, but calls to and from the PSTN don't work. I thougt that there could be the problem, that the IP-address for the gateway-entry in my CCM is only the address from the first NIC. Have you got a clue ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...