Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Gateway 2651xm configuration problem

Excuse my limited knowledge but I really need to know how to change the "Type:" from "Unknown" to "National".

Calling Party Number i = 0x0081, '492xxx9xxx69'

Plan:Unknown, Type:Unknown

thanks in advance

Janis

2 REPLIES

Re: Gateway 2651xm configuration problem

Janis,

You can change the called/calling party number type in Callmanager administration. Go to Device -> Gateway. Find your gateway and find the originating port. You will see Called party IE number type and Calling party IE number type. The default for these is Cisco Callmanager which works well most of the time. If you are outside of the US or are connecting to a PBX, another type may be required. The type can also be changed on a more granular basis (based on called number, etc) by using voice translation rules on the gateway. Take a look at the following link.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml#type_plan

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Gateway 2651xm configuration problem

Thank you, Brandon.

Fotunately I found it myself on the cisco sites.

The right command to change the TYPE is:

-----------------------------------------------------

Router(config-if)# isdn map address telephone-number plan isdn type national

-----------------------------------------------------

Have a nice day, Brandon.

113
Views
3
Helpful
2
Replies
CreatePlease login to create content