12-07-2002 03:20 PM - edited 03-12-2019 09:51 PM
I an working on the lab and trying this scema:
3640, 2621, 2612. All on one ethernet segment.
2612 work as gatekeeper ( 8 flash + 48 ram). This is not enough but it is just for test. So I download software from tftp. I have messages thae gatekeeper overloaded....
I can make register one gw to gk. But second give me this message:
%CCH323-2-GTWY_REGSTR_FAILED: Gateway R5 failed to register with Gatekeeper GK-ZB even after 2 retries
If I do " no gateway" on registered gw that it unregister and another one register at the moment....
What could it be?
12-12-2002 10:54 AM
The output of the Error Message Decoder for the particular error message you have is in the link below. Recommended action is also included in it. Check this out:
Regarding the use of 'no gateway' command, I am not very sure of it. Anybody having configured the same?
12-12-2002 11:06 AM
Hi levter, first check if the voip id configured on ethernet interface of gateway match with the zone of gatekeeper.
(h323-gateway voip id zoneOfgk ipaddr ip.of.gk).
If this is ok, try to add this line to all of your dial-peer pots in the gateways:
!
dial-peer voice xxx pots
no register e164
!
Regards
Ezequiel Colombo
[Argentina]
12-12-2002 02:57 PM
Thank you to all who did reply.
I solve it.
It was just wrong software...
I had right config...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide