System > System Parameters > Gateway Configuration
Is the not a way to display a friendly name for the Gateway Name in ART? It currently shows IP addresses for our H323 gateways, management is looking at the reports and wanting to know the ip address to name mapping -jason
Re: Gateway names in ART (or CAR or whatever it's called now)
You can view the information from either on SQL query by gateway information. Or through ART (Administrative Reporting tool). If you dont have it installed on the call manager, then click on Application and install plugin and then install the software. The default username/password is admin/admin.
Those are the only 2 ways I know to find out which gateway the call is passing through. The only differnce in both of these are the sql is not user friendly but is in real time, ART is 24hr. delayed but the reports are provided in readable format for the end user.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...