Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Gateway Tone-on-Hold volume levels

Does anyone know how to adjust the auto generated Tone-on-hold volume which is generated to the caller on hold over the pstn?

2 REPLIES
New Member

Re: Gateway Tone-on-Hold volume levels

Hello,

This is taken from Cisco documentation:

Adjusting the audio levels on the Cisco Access Digital Gateway DT-24+/DE-30+ requires the following software:

- Cisco CallManager release 2.3 or 2.4

- Cisco Digital Access load file D003G024.bin

- Cisco DickTracy utility

Steps to adjust the audio levels on the Cisco Access Digital Gateway DT-24+/DE-30+ using the DickTracy utility are given in this document.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_release_note09186a00800b7567.html

Thanks,

Re: Gateway Tone-on-Hold volume levels

Thanks for the reply, I should have been more precise, I have an IOS gateway 26xx, 36xx and these are the types of gateways I wish to adjust the Tone-on-Hold volumes.

Regards,

Todd

103
Views
0
Helpful
2
Replies
CreatePlease to create content