i have a case where my gateway has one ethernet interface and 2 serial interfaces. First, i decide to register the GW with a GK using the ethernet interface as the voip inteface. Then i change my mind and issue the command "no gateway" to stop using he GK and just do GW peering. the strange thing now is that for every Setup this GW gets, it responds with a CallProceeding that has its Serial interface IP as its media address. what do i need to do to force this GW into using its Ethernet inteface to send/receive media?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...