I removed the hard drive on the SPE Unity blade on an ICS7750, connected that hard drive and a 40 GIG Western Digital Hard drive to the IDE bus of a Compaq Workstation. I booted with Symantec Ghost 2002 and imaged the drive. The image completed successfully. I installed the new drive into the SPE blade and it wouldn't boot. I did the same thing with a Call Manager SPE blade with the same result.
Will the Bios on the SPE blade only recognize drives of a certain size ?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...