Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
297
Views
0
Helpful
1
Replies

Glenarye paging

brad.swanson
Level 1
Level 1

‎01-25-2001 11:55 AM - edited ‎03-12-2019 11:03 AM

Hi. Anyone with knowledge of tying in a Glenarye paging system to the CCM? We use a 2600 for connection to the PBX now for a small pilot (20 7960 phones) we are running. Not looking for lots of details, just someone to say that this can be accomplished without reinventing the wheel!

Thanks,

Brad

Labels:
0 Helpful
1 Reply 1

briggs.simon
Level 1
Level 1

‎01-26-2001 06:31 PM

Have not done it with the Glenarye specifically but the same should hold true, we used an analog gateway (VG200 with 4 FXS ports) and an external 3rd party amplifier to tie into the paging system. You dial an extension wait for the confirmation tone and start talking.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents