Hi. Anyone with knowledge of tying in a Glenarye paging system to the CCM? We use a 2600 for connection to the PBX now for a small pilot (20 7960 phones) we are running. Not looking for lots of details, just someone to say that this can be accomplished without reinventing the wheel!
Have not done it with the Glenarye specifically but the same should hold true, we used an analog gateway (VG200 with 4 FXS ports) and an external 3rd party amplifier to tie into the paging system. You dial an extension wait for the confirmation tone and start talking.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.