cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
672
Views
0
Helpful
1
Replies

Global MWI Resync in Unity 4.0 ??

tedgarner
Level 1
Level 1

Hi folks;

It used to be in the Unity Admin pages under "Switch" you could specify when the system should do a global MWI resync. You could also force an immediate resync. When I load up Unity Admin on my 4.0(2) installation, there is no "Switch" selection. Where to I configure the MWI resync now?

1 Reply 1

oliviers
Cisco Employee
Cisco Employee

Things changed a bit in 4.0. What used to be configured on the SA for a switch is now done via the UTIM (Unity Telephony Integrations Manager). It can be found at \Start\Programs\Unity\Manage Integrations.

There's a small blurb about this here...

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_unity/sag/sag402/ex/sag_0260.htm#1441988

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: