Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

->FXO->FXS-> call transfer not working...

We have cisco2811 with c2800nm-adventerprisek9-mz.124-16 and 1 FXO + 2 FXS ports.

at this moment i use CME B-ACD to auto answering and forward call to internal fxs port.

problem - this call, terminated to fxs, cann't be transferred by using flash button on analog phone(to transfer call from fxs to fxs port i use app-h450-transfer.2.0.0.9.tcl)

Can somebody tall me WHAT to use to make transfer feature working??

my config in attachment

9 REPLIES
Hall of Fame Super Gold

Re: ->FXO->FXS-> call transfer not working...

Hi,

do you have the documentation for app-h450-transfer ?

I think the service is meant to be configure on incoming dial-peer ?

Hall of Fame Super Gold

Re: ->FXO->FXS-> call transfer not working...

Another thing you can try, is "SCCP feature mode for FXs port". That would let you have the analog phones with feafures like an IP phone:

http://cisco.com/en/US/products/ps6706/products_feature_guide09186a00806cab75.html

Hope this helps, please rate post if it does!

New Member

Re: ->FXO->FXS-> call transfer not working...

Configuring Feature Mode for SCCP Analog Phones

This task configures feature mode for SCCP analog phones on the voice gateway and enables SCCP analog phones to invoke features using feature access codes after hook flash.

Prerequisites

You must first configure full consultation transfer on Cisco CallManager using the transfer-system full-consult command in order for feature mode to work on the voice gateway.

SUMMARY STEPS

1. enable

2. configure terminal

3. stcapp call-control mode feature

my IOS says that didn't know "stcapp" command....

Hall of Fame Super Gold

Re: ->FXO->FXS-> call transfer not working...

It requires 12.4XC or later, you have 12.4 mainline.

New Member

Re: ->FXO->FXS-> call transfer not working...

we currently using c2800nm-adventerprisek9-mz.124-16.bin,

this ios didn't work with stcapp too?

Hall of Fame Super Gold

Re: ->FXO->FXS-> call transfer not working...

It does not, as I said before it requires 12.4XC or later, you have 12.4 mainline.

New Member

Re: ->FXO->FXS-> call transfer not working...

do you have the documentation for app-h450-transfer ?

I think the service is meant to be configure on incoming dial-peer ?

will try use app-h450-transfer on incoming dp.

New Member

Re: ->FXO->FXS-> call transfer not working...

All fixed with:

B-acd tcl script to serv incoming PSTN calls, sccp + e-phones binded to all fxs ports.

As a result - welcom pprompt + transfer to operator + moh + all standart features at internal calls.

Thanks for all for help!

A houp my 2 week sex with cisco wil be helpful for somebody...

254
Views
6
Helpful
9
Replies