Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

H.323 and MGCP on same Gateway

Hi all,

we're using CCM 3.2(2c) and a 3660 with BRIs (PSTN connection) and FXS interfaces as H.323 gateway. Due to billing requirements I now would like to access the FXS ports using MGCP.

Does anyone know if it is possible at all (especially in CCM) and if yes are there known problems.

Regards

Gunnar

2 REPLIES
Cisco Employee

Re: H.323 and MGCP on same Gateway

Hello Gunnar, unfortunately configuring H323 and MGCP in the same gateway is not supported.

-ben

New Member

Re: H.323 and MGCP on same Gateway

We have gateways configured with both H.323 and mgcp and there has not been any issue. However any endpoint (DS0 or analog port) will only use one of them, not both.

130
Views
0
Helpful
2
Replies