Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

H.323 client

Hi,

I have an H.323 client (a proprietary software running on WindowsXP).

In the configuration I can only type the IP address of a gateway (I set up the IP Address of callmanager).

In Callmanager I created a new H323 device with the IP address of the h323 client.

Calls from client to callmanager are ok.

Calls from callmanager to client have the following problems:

1) after 5 secs start the first ring

2) when the client try to answer the call keep on ringing (so it is impossible to answer)

Is there a way to debug this issue?

Regards

2 REPLIES
Bronze

Re: H.323 client

Following are the debug commands you can use for debuuging h.323 gateway:

debug voip ccapi inout

debug h225 q931

debug h225 asn1

debug h245 asn1

debug h225 events

debug h245 events

debug ras

http://cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080207ec6.shtml

H.323 callmanager interaction issues:

http://cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094604.shtml

New Member

Re: H.323 client

Hello,

on first Link "http://cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080207ec6.shtml"

I'like to use the Voice Debug Lookup tool.

It don't work porertly. There are no entries in the dropdownlists.

285
Views
4
Helpful
2
Replies
CreatePlease to create content