Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

H.323 gateway question

Here's my problem:

When a call comes into my h.323 g/w (2620), our 7960's display the destination-pattern configured. SUch as "From 9". Is there any commands that I can use to remedy this problem? I have 8 analog lines and they all do the same thing. I'd like to tag a e.164 address to each port if possible. Any suggestions?

  • Other Collaboration Voice and Video Subjects
1 REPLY
New Member

Re: H.323 gateway question

I figured out the answer....its an IOS config under your dial-peer config.

dial-peer voice 1 pots

answer-address 4570

destination-pattern 9T

port 1/0/0

There you go...

88
Views
0
Helpful
1
Replies