Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H.323 & Netmeeting

I have problems when try to connect two side from WAN with call from Netmeeting to Analog Phone.

The Phone to Phone call work well, but Netmeeting to Phone no..

Any Know wath happen?

Regards.

Rodrigo

1 REPLY
New Member

Re: H.323 & Netmeeting

Please check your codec settings. We have found that netmeeting likes to use G.711 codecs and you have to force it to use G711. Of course, Microsoft doesn't call it G711:

Configure Microsoft NetMeeting for Voice over IP

To configure NetMeeting to work with Voice over IP, complete the following steps:

Step 1 From the Tools menu in the NetMeeting application, select Options. NetMeeting will display the Options dialog box.

Step 2 Click the Audio tab.

Step 3 Click the "Calling a telephone using NetMeeting" check box.

Step 4 Enter the IP address of the Cisco AS5300 in the IP address field.

Step 5 Under General, click Advanced.

Step 6 Click the "Manually configured compression settings" check box.

Step 7 Select the CODEC value CCITT ulaw 8000Hz.

Step 8 Click the Up button until this CODEC value is at the top of the list.

Step 9 Click OK to exit.

Good luck.

111
Views
0
Helpful
1
Replies
CreatePlease login to create content