Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

H.323 to H.320

I have Cisco's 3510 MCU and 3520 gateway with a MCM as gatekeeper. I am trying to connect gateway to a Picturetel Montage by V.35. I am having a problem getting 768K conversations to work. Montage port is set for 768K. Prefix is set for 768K. Call registers with the gatekeeper. Montage can see frames from Polycom Viewstation fine but the Polycom shows great variance in frames. 1.5-3.0 with it jumping up to 29.X sometimes. I do not know what is the problem but it appears to be timing or protocol. Does anyone have any ideas?

1 REPLY
New Member

Re: H.323 to H.320

I suggest checking the version of software used on the GW. 768k support did not appear until version 2+.

122
Views
0
Helpful
1
Replies