I have a cisco 2651 gatekeeper proxy h323 with several endpoints registered on it. I just enabled the security token for registration in the gatekeeper and define the passwords of the endpoints in a Cisco ACS. The endpoints can succefully register in the gatekeeper but the proxy h323 (witch runs in the same machine) can't register because it doesn't sends a token in the RRQ. Someone knows How do I configure an h235 password for the proxy?. Thanks in advance.
I already tried this option before in an IOS (12.2(13)) with dual support (gateway and gatekeeper), i configured the proxy and the security password for the gateway but the proxy did not use the gateway password to create the required token in its RRQ message. I still wondering how to do this.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.