Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H323 gateway configuration with E1 PSTN

Hello,

can somebody help me with a configuration template/example for a H323 gateway that is connected to the PSTN via an E1 controller.

Thanks in advance!

1 REPLY
New Member

Re: H323 gateway configuration with E1 PSTN

controller E1 0/0/0

pri-group timeslots 1-31

!

controller E1 0/0/1

pri-group timeslots 1-31

!

interface Serial0/0/0:15

no ip address

no logging event link-status

isdn switch-type primary-net5

isdn incoming-voice voice

isdn T310 75000

isdn send-alerting

isdn sending-complete

no cdp enable

!

interface Serial0/0/1:15

no ip address

no logging event link-status

isdn switch-type primary-net5

isdn incoming-voice voice

isdn T310 100000

isdn sending-complete

no cdp enable

!

voice-port 0/0/0:15

!

voice-port 0/0/1:15

!

dial-peer voice 1 pots

tone ringback alert-no-PI

destination-pattern 9..T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

port 0/0/0:15

!

dial-peer voice 8000 voip

description **** IVR for welcome message ****

preference 1

destination-pattern (dest. Pattern Here)

voice-class h323 1

session target ipv4:10.3.1.198

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 4000 voip

description **** Extension dialing ****

destination-pattern 4...

progress_ind setup enable 3

voice-class h323 1

session target ipv4:10.3.1.196

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 2 pots

tone ringback alert-no-PI

description **** Incoming for pool 52045.. ****

incoming called-number 2152045..

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 4200 voip

description **** Extension dialing ****

preference 2

destination-pattern 4...

progress_ind setup enable 3

voice-class h323 1

session target ipv4:10.3.1.198

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 4 pots

tone ringback alert-no-PI

incoming called-number 2152046..

direct-inward-dial

port 0/0/1:15

!

dial-peer voice 5000 voip

description **** IVR max-out goes to Operator ****

destination-pattern 500.

voice-class h323 1

session target ipv4:10.3.1.198

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

dial-peer voice 5001 voip

description **** IVR max-out goes to Operator ****

preference 2

destination-pattern 500.

voice-class h323 1

session target ipv4:10.3.1.196

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad

!

!

Use num-exp command to send the incoming number to CCM.

1120
Views
0
Helpful
1
Replies
CreatePlease login to create content