Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H323 gateway questions

I have configured H323 gw... and it works...but...

Question number one....

While I call from outside PSTN to H.323 gw...Why I should hear 2 ringback signals before I hear dial tone ..if I have no connection plar. And I can be connected to some internal number if I have connection plar configured.

Can I change it?

P.S. Call from analog phone (fxs port in the same router/gw as fxo) have no this 2 additional ringbacks...

Question number two....

I can call from analog phone to IP phones... but...when I trying to call CTI numbers I cannot do it.... And when call is forwarded to voicemail... it fail...(like somebody off-hook and then on-hook)....

I can call from IP phones voicemail...it works...

Calling space it not issue too...

What is it?

Can anybody help?

Thanks in advance...

2 REPLIES
New Member

Re: H323 gateway questions

Hi, regarding your secound question it looks like you have a CODEC proplem, you sould check the codec configuration on the gateway.

New Member

Re: H323 gateway questions

You absolutely right.... I already figured out....

Default codec was g729....For all CTI ports it should be g711...

106
Views
0
Helpful
2
Replies