Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

H323 on VG200

What are the config needed on VG200 to act as H323 gateway. Is there any sample configurations available ?

3 REPLIES
Community Member

Re: H323 on VG200

The VG200 works fine as an H323 gateway. The configuration you need really does depend on what you are trying to do, but the following is an example that may help. Don't forget to have the "ip routing" statement somewhere in your config or you will have very bad or no speech quality.

If you are bouncing through router hops too, as well as setting up QoS you will need to bind the correct IP address for VoIP to your VG200s LAN interface using something like this:

h323-gateway voip bind srcaddr 192.168.32.1

Sample follows with output omitted....

!

voice class codec 1 # preferred codec sequence (only if required)

codec preference 1 g711alaw

codec preference 2 g729r8

!

voice class h323 1 # a way of modifying this setting (only if required)

h225 timeout tcp establish 3

!

voice-port 1/0/0 # the physical port settings

compand-type a-law

cptone GB

codec g711alaw

!

voice-port 1/0/1 # the physical port settings

compand-type a-law

cptone GB

codec g711alaw

!

dial-peer voice 300 voip # the logical settings for o/g numbers dialled with a leading "1" and 3 other digits

preference 1

destination-pattern 1...

progress_ind setup enable 1

voice-class codec 1

voice-class h323 1

session target ipv4:192.168.32.32

dtmf-relay h245-alphanumeric

!

dial-peer voice 301 voip # the logical settings for o/g numbers dialled with a leading "4" and 3 other digits

preference 2

destination-pattern 4...

progress_ind setup enable 1

voice-class codec 1

voice-class h323 1

session target ipv4:192.168.32.32

dtmf-relay h245-alphanumeric

!

dial-peer voice 1 pots # associates a DN of "5000" to this physical voice port

destination-pattern 5000

port 1/0/0

!

dial-peer voice 2 pots # associates a DN of "5001" to this physical voice port

destination-pattern 5001

port 1/0/1

!

Community Member

Re: H323 on VG200

look in the software configuration guide that came with your vg200. chapter 3 has a pretty good overview of basic setup.

Community Member

Re: H323 on VG200

If you are familiar with other gateways such as 36XX, 26XX, 175X the VG200 configures the same.

150
Views
0
Helpful
3
Replies
CreatePlease to create content