Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H323 - outgoing call not working

Hello ,

i have configured h323 . out going call is working for my ext 0223 but i can call outside (PSTN) from same ext.

Dialed Number analyser Results :


  • Results Summary
    • Calling Party Information
      • Calling Party = 0223
      • Partition = PT-INTERNAL
      • Device CSS =
      • Line CSS = CSS-MOBILE
      • AAR Group Name =
      • AAR CSS =
    • Dialed Digits = 33000883
    • Match Result = BlockThisPattern
    • Route Block Cause = Unallocated Number
    • Called Party Number =
    • Matched Pattern Information
      • Pattern =
      • Partition =
    • Pattern Type =
    • Time Zone =
    • Outside Dial Tone = NO
  • Call Flow
    • TranslationPattern :Pattern=
      • Partition =
      • Positional Match List =
      • Calling Party Number = 0223
      • PreTransform Calling Party Number =
      • PreTransform Called Party Number =
      • Calling Party Transformations
        • External Phone Number Mask = NO
        • Calling Party Mask =
        • Prefix =
        • CallingLineId Presentation =
        • CallingName Presentation =
        • Calling Party Number = 0223
      • ConnectedParty Transformations
        • ConnectedLineId Presentation =
        • ConnectedName Presentation =
      • Called Party Transformations
        • Called Party Mask =
        • Discard Digits Instruction =
        • Prefix =
        • Called Number =
  • Alternate Matches
    • Note: Information Not Available

Please advise

2 REPLIES
New Member

H323 - outgoing call not working

Scrn.jpg
please see the Screen shot of RP

H323 - outgoing call not working

Looks like you are missing the 9 when dialing out accourding to your Route Pattern.

Please rate helpful answers!

385
Views
0
Helpful
2
Replies
CreatePlease login to create content