I have on my network 2 different h323 (non cisco) gateway in two different route groups, also I have a route list with the two route groups, when I make calls that point to that route list the callmanager does not search in the second route group if the first one returns busy, the only way to make the call go to the second gateway is disconnect the first one. From the cco I have read than if i put the Stop Routing on User Busy Flag -> False in service parameters, it should resolve the problem, but did not. This parameter is a inter-cluster-trunk parameter.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...