Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

H323 to MGCP problem

Hi all

I recently upgraded from H323 to MGCP on 2611XM router One problem I got was the called number presented on the IP phone disappear when the call is connected. Eg. Usually under H323 when I dial 96597817 the IP phone dislay "To 96597817". When converted to MGCP all I get is "To ". Any ideas?

1 REPLY
Silver

Re: H323 to MGCP problem

In case of a MGCP Gateway verify if the tab "Send Calling Name In Facility IE" is checked in the "PRI Protocol Type Specific Information" Section of the Gateway.

This should solve the issue. If not, it could also be a telco side problem.

87
Views
0
Helpful
1
Replies