Has anyone had any experience, good, bad or indifferent with bringing a PRI in on a 2 PRI port WIC card on a 3600 and sending the call immedialty out the 2nd port? I am doing a slow migration to CM but need to continue to bring certain DIDs in and send them over the 2nd PRI port to a legacy phone system. I am using a 3640 running 12.(8)T4. I am going to go live with it later this week. On a previous post one of the Cisco guys mentioned the possibility of some bugs or wierd behavior when hairpinning a call like this. Wanted to see what I should expect. Anyone?
In my opinion, you should be fine, this is a simple scenario. There were some bugs related to this issue, but you seem to be on a good release of IOS. But rule of thumb is... Expect the worst and hope for the best... :)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...