Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Hardware Conference Bridge

Does anyone know if an NM-HDV-1E1 card (its an E1 voice card with DSP processors) installed on a 2610 can be used as a hardware conference bridge?

On the CallManager 3.1 administration it requires you to specify a MAC address for the hardware conference bridge. Can you use the NM-HDV card for this? or maybe the only HW conference device available is the WS-6608 E1 blade?

Thanks

1 REPLY
New Member

Re: Hardware Conference Bridge

I've used the vg200 with an NM-HDV with 2 PVDMs in it for conferencing. I would think any device that accepts an NM-HDV where the NM-HDV accepts PVDMs would work for conferencing.

I don't know if the NM-HDV with a slot for E1 has conferencing ability.

102
Views
0
Helpful
1
Replies
CreatePlease to create content