Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Has anyone successfully installed a 6624 FXS Blade in a Catalyst 6k

Hi,

I am having trouble installing the 24 port fxs blades in a catalyst 6k chassis and getting them to work register with call manager.

Has anyone got this to work with in a Catalyst 6009 chassis with a layer 2 only, version 1 supervisor?

I have tried 3 different fxs blades (all with the same hardware & firmware levels) and 3 different chassis in two different call manager installations, with no success.

The fxs blades do not broadcast for an IP address from a DHCP server nor if manually configured, attempt to contact the tftp to start to download the config and load files.

Any help would be appreciated.

1 REPLY
Cisco Employee

Re: Has anyone successfully installed a 6624 FXS Blade in a Cata

Yes, this has been done successfully by many people in the field.

Can you tell me which version of CatOS you are running on the supervisor?

112
Views
0
Helpful
1
Replies
CreatePlease to create content