Have anyone use AS5300 to connect Bell FGD trunk in North America/ Canada?

[v.chow]

I have a AS5300 and one Bell T1 FGD trunk. But I cannot make a call. It seem signaling problem. Does anyone know the exact T1 configuration at the "controller t1"?

[Chester Rieman]

Here is the URL for it:

http://www.cisco.com/en/US/partner/tech/tk652/tk653/technologies_troubleshooting_procedures09186a00801040bc.shtml#config1

[v.chow]

But do you know is that any variant of the FGD. From the Bell spec. the AS5300 gateway would sometime give two winks and sometime three wink for digits collection which depends on the special digits like # or a.

Would the same command work with the FGD?