Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Have anyone use AS5300 to connect Bell FGD trunk in North America/ Canada?

I have a AS5300 and one Bell T1 FGD trunk. But I cannot make a call. It seem signaling problem. Does anyone know the exact T1 configuration at the "controller t1"?

2 REPLIES
Cisco Employee

Re: Have anyone use AS5300 to connect Bell FGD trunk in North Am

New Member

Re: Have anyone use AS5300 to connect Bell FGD trunk in North Am

But do you know is that any variant of the FGD. From the Bell spec. the AS5300 gateway would sometime give two winks and sometime three wink for digits collection which depends on the special digits like # or a.

Would the same command work with the FGD?

103
Views
0
Helpful
2
Replies
CreatePlease to create content