Hi There, I am not sure if this is the correct forum.
I would like to setup my Cisco Unity v4 to forward a call to an individual's cell phone and if that individual doesn't pick up the phone call I would like the voice message to be left on his desk phone (7940)
if you set the behavior to attempt transfer to and choose yes, ring subscriber at this extension doing a supervised transfer if the number of rings is less that the amount your mobile VMs takes to answer it will go back to unity's VM
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.