Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HDA and 3640 with MGCP Call Manager ver 3.2.2c

I am running Call Manager 3.2.2c and have a 3640 (12.2.11T) with an HDA analog card. I am using MGCP and have no issues with the PRI (on a 2T1) but I cannot use the HDA . I assume I must use H.323 in order to use the HDA. Is it possible to run both MGCP and H.323 on the same gateway? If so how do I accomplish this.

Any feedback would be appreciated.

Thanks

3 REPLIES
New Member

Re: HDA and 3640 with MGCP Call Manager ver 3.2.2c

I think service pack C for 3.2.2c adds support for the HDA using MGCP

Re: HDA and 3640 with MGCP Call Manager ver 3.2.2c

I have the same config, and have the HDA working via mgcp fine, but I cannot get the PRI to register, any suggestions? send me an email: tringwelski@forsythesolutions.com

Thanks,

TR

New Member

Re: HDA and 3640 with MGCP Call Manager ver 3.2.2c

I think if you try 12.2.11 T you should be all set. I had the same issue and when I changed to the newer version, the issue went away.

How did you get the HDA card to register? I don't even have an option to use the HDA.

98
Views
0
Helpful
3
Replies