Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HDV E1 connections with Lucent Definity G3 PBX

I have a problem with connecting with the PBX. The PBX phone cannot call the IP phone and neither can do the other way round. Just no response whatsoever. However, the E1 controller and the lines are up.

My config for 3662 is:

voice-card 2

!

ip subnet-zero

!

!

no ip finger

no ip domain-lookup

!

call rsvp-sync

controller E1 2/0

framing NO-CRC4

ds0-group 1 timeslots 1-15,17-31 type r2-analog r2-compelled ani

cas-custom 1

unused-abcd 0 1 1 1

country china use-defaults

answer-signal group-b 1

!

!

interface FastEthernet0/0

ip address 192.168.1.254 255.255.255.0

duplex auto

speed auto

!

interface FastEthernet0/1

no ip address

shutdown

duplex auto

speed auto

!

ip classless

no ip http server

!

!

voice-port 2/0:1

cptone CN

!

dial-peer cor custom

!

!

!

dial-peer voice 101 voip

destination-pattern 1111

session target ipv4:192.168.1.1

codec g711alaw

!

dial-peer voice 102 voip

destination-pattern 2222

session target ipv4:192.168.1.1

codec g711alaw

!

dial-peer voice 201 pots

destination-pattern 9T

port 2/0:1

prefix 9,

!

dial-peer voice 202 pots

destination-pattern ...

port 2/0:1

We changed the PBX settings, mostly the signaling part, but not too much with the dialing plan or some system parameters. The change is made according to a Cisco Web Docu for setting E1R2 with Lucent PBX, though county is different.

I also tried by using r2-digital r2-compelled, but with no use.

The cable is RJ-48-BNC.

Any one know how to change the setting of PBX? I think the only part may be wrong is the sinaling because we tried FXS phone to talk with IP phone and it worked.

Can we use E1 E&M sigaling? I think this should be simpler. But how to match the setting on router and PBX?

Pls. post reply or send email to zhao_shi@hotmail.com. Thanks a lot.

1 REPLY
New Member

Re: HDV E1 connections with Lucent Definity G3 PBX

Hi rushrus

yes you can use your E1 with E&M signalin I have this configuration in my Voip Implementation

try with this command on you router

controller E1 1/0

framing NO-CRC4

ds0-group 0 timeslots 1-12 type e&m-immediate-start

cas-custom 0

description Pruebas de Voz sobre IP en La WAN

But remember configue your PBX trunk-gruop with the follow settings

Group type : tie

Trunk Type (in/out) : immed/immed

Regards

Now I have a quiestion for you

I try to configure this on with FXS port but really I dont know which kind of trunk and settings do I have to use.

my e-mail is eduardo.ramirez@oracle.com

109
Views
0
Helpful
1
Replies