Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HDV modules and Conferencing

Hello..

If I have a NM-HDV-1T1-24 module on a 2650 router that has 2 PVDM-12s, can I add an addtional 3 PVDM-12s to this module and use those strictly for conference calling?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: HDV modules and Conferencing

When you create the pri-group, the dsp's needed to service all of the channels will be automatically allocated, this is 2 PVDM's (6 DSP's).

Here is a link that touches on dspfarm DSP usage:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080108fe6.shtml

See the section "Planning for the Number of DSPs Installed"

3 REPLIES
Bronze

Re: HDV modules and Conferencing

Yes, this will work fine.

New Member

Re: HDV modules and Conferencing

What are the restrictions on how they have to be divided up? There would have to be enough for the PSTN gateway access, so how many would that leave me for conferencing? Assume all calls on the are G.711.

Thanks,

Colin

Bronze

Re: HDV modules and Conferencing

When you create the pri-group, the dsp's needed to service all of the channels will be automatically allocated, this is 2 PVDM's (6 DSP's).

Here is a link that touches on dspfarm DSP usage:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080108fe6.shtml

See the section "Planning for the Number of DSPs Installed"

93
Views
0
Helpful
3
Replies
CreatePlease login to create content