Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Help configuring CUBE

Hi,

I apologize if at some point I don't use the correct terminology. I have just received a CUBE but I am not sure where to start. Here is how it will be connected:

outsideCube ----metroE link ---- myCube --- myFirewall ---myinside network

I would like to know how to configure the following:

1. Cube itself. What do I need to configure so I can neighbor it with the other one?

2. I need to enable the gateway feature.

3. I have CCM 4.1, should I register it with the CUBE or Gatekeeper? How?

4. Dial-peer and Dial-plan

I really need some help in order for me to get this done as soon as possible.Thank you very much.

1 REPLY

Re: Help configuring CUBE

This is all pretty heavily dependent on the protocols you're using.

Here's a link to a good CUBE configuration guide using a SIP trunk and CUCM:

http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_example09186a00808ead0f.shtml

-nick

402
Views
0
Helpful
1
Replies
CreatePlease to create content