Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Help configuring VIC-4FXO-M1 on MRP300

I've had a VIC-4FXO-M1 in my MRP300 for years and am finally getting around to needing it. I've upgraded the IOS to 123-7.XR6, but the IOS is not recognizing the FXO ports when I do "show version". No "voice-port" entries appear in the IOS config. When I type "show diag", the VIC is shown so I don't understand why I don't get "voice-port" entries in IOS. Please help! My only guess, based on scattered doc I've found, is that perhaps I need to purchase a PVDM-4 before I can get this working.

"show diag" output:

Packet Voice DSP Module Slot 0:

Not populated

Packet Voice DSP Module Slot 1:

Not populated

WIC Slot 0:

Four port FXO-North America/M1 Voice Interface Card

Daughter card-Version 4 TLV Cookie Format

Hardware Revision : 4.0

Part Number : 73-7119-04

Board Revision : A0

Deviation Number : 0-0

Fab Version : 03

PCB Serial Number : JAD06520SG1

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Top Assy. Part Number : 800-17617-02

Connector Type : 01

Product (FRU) Number :

1 REPLY
Silver

Re: Help configuring VIC-4FXO-M1 on MRP300

I guess you are right. Voice-port is not showing up due to lack of DSP's.

regards,

Anup

112
Views
0
Helpful
1
Replies