Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

help for CBWFQ

Hello,

I used method CBWFQ to apply a priority to strategic application. However to evaluate the real contribution of this solution, I need to present quantitative measurements corresponding for example to the numbers of packets lost for a flow given (indicated by an address source) before and after the application of the policy. I don’t know if there is commands which allow this and if the command "s queue serial" is useful in this case.

Thanks

3 REPLIES
Purple

Re: help for CBWFQ

Hi,

The best command to use to view pre/post-policy stats when using CBWFQ is 'show policy-map interface '

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: help for CBWFQ

Yes, you are right, with « sh policy map » I can confirm that the rate of loss corresponding to application A is X. But I must compare it with the same percentage of loss before the application of policy. Then how to obtain this rate?

Purple

Re: help for CBWFQ

If that is what you want, I suggest you use an application like iperf which will give you end-to-end statistics on traffic sent/received. Then, you compare these with CBWFQ disabled and then with it applied.

Hope that helps - pls rate the post if it does.

Paresh

89
Views
0
Helpful
3
Replies