Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Help, Gatekeeper and ATA Registration Problem

I have a registration problem with a gatekeeper IOS and ATA's 186 H323 Signaling.

When lost a wan connection the problem it happens, when the communication is ok the ATA not is registered in gatekeeper

I check the IP UDP and TCP connection to the ATA LAN to the gatekeeper interface an is ok, the ras packeets and messages are received to the gatekeeper

In debug ras indicate that the paquets are received

This is the configuration and debug ras output

gatekeeper

zone local gk.aeromexpress.com.mx aeromexpress.com.mx

zone prefix gk.aeromexpress.com.mx 111*

zone prefix gk.aeromexpress.com.mx 111* gw-default-priority 10

accounting username xxx

gw-type-prefix 111* default-technology gw ipaddr 172.25.18.53 1720

bandwidth total default 720

bandwidth session default 64

bandwidth session zone gk.aeromexpress.com.mx 768

bandwidth remote 720

bandwidth check-destination

no shutdown

DEBUG "THE PROBLEM IN THIS OUTPUT IS WHIT IP 172.25.142.3"

2 REPLIES
Green

Re: Help, Gatekeeper and ATA Registration Problem

A default configuration for local zone does not allow the H.323 terminals to put calls through directly to the destination. All terminals need to place calls through an H.323 proxy. As the Cisco ATA 186 is a terminal, it does not place a call to the default gatekeeper configuration.

http://www.cisco.com/warp/public/788/voip/ata186_no_call_gk.html

//G

New Member

Re: Help, Gatekeeper and ATA Registration Problem

gogasca

I don't understand if it is the case.

in the normal operation all ATA's work's and they appear registered in gatekeeper, but when exist a lost WAN and when the connection again is operating, the ATA not is registred reason why calls cannot be made or be received

117
Views
0
Helpful
2
Replies
CreatePlease login to create content