scenario is i have ccme running at present. we have 2 T1 CAS e&m interfaces working. at present i have COR configured to allow private line users to use those lines and no one else. what i wanted to find out was if it were possible, with my configuration, to associate the private line port, directly with the direct line button, meaning, if he/she presses the direct line button, it will off-hook the port automatically.
issue is that i have an integration with a PBX along the the CME and the COR configured does not apply to the remote end router. therefore, when the lines get saturated (everyone uses the 2t1 on ccme for inbound and outbound), ppl on the pbx end has the ability to use the private line to make outgoing calls.
any ideas will be greatly appreciated. as i have configured a temp solution where the private line users, press 1 then thier number to make the call. its temporary, since the private lines are associated with managers, and they want total transparency therefore, removing the 1.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...